Note that the connectors have to be on the OUTSIDE of the bike hole (They will not reach to the mounting location otherwise, let me tell you how annoying that was to notice).Ĥ) Connect the turn signal wire connectors to the new license plate holder/turn signal piece. After that remove the four main mounting boltsĢ) Once the old tail piece is removed, flip it over and disconnect the three connectorsģ) Run the turn signal wiring through the new bracket center hole. Requires removing the space wing lower plastic that consists of a few bolts As such, I thought I'd post some general steps: Moreover, nothing outside of a packing slip came with the package, so install had to be deduced. I really like the kit That being said, I was annoyed that there were no installation instructions on the new rage website for the Supersport yet. Included hardware was poorly fitting for me Turn signals are great, and plate is well tucked. Thought I'd share some install experiences with this to save some other people some headaches.Īwesome, clean looking kit post install.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |